Assembly Instructions for Deluxe Brine Shrimp Hatcher

1.  Insert Nuts into Base and then attach supports with screws.  Hold Base Upside Down.

Nut Assembly with arrows.png
Support Assembly.png

2.  Assemble Ring as shown.  Not usually required, but you may glue these parts together with either a cyanoacrylate adhesive or silicone. 

Base Assy with arrow.png


3.  Assemble Bumpers to Ring Base (6X) 

Ring Bumper Assy.png

4.  Assemble Ring to Supports (3X) 

Ring Base Assembly Pt 2 with arrow.png

5.  Cut bottom off of 2L bottle (not included) and then attach to base.  Thread tightly to prevent leaks

2L Bottle Assembly with arrow.png

NOTE:  It is best to remove the plastic band near the threads of the 2L bottle


6.  Assemble Bumbers (3X) to top to reduce noise from air pump vibration

Bumber Assy with arrow.png


7.  Assemble Top to 2L Bottle

Top Assembly with arrow.png8.  Attach air hose.  Optional - The included cable tie can be used to secure air hose to prevent leaks, but is generally not needed with the included tubing.  Use needle nose pliers to pull cable tie tight to prevent leaks.

Air hose assembly with arrow.png
cable tie assy.png


9.  Assemble Plug - TIGHTEN prior to use

Plug assembly with arrows.png

Completed Assembly

BRS 3 v24-Deluxe Model NO Spoons.png